(Printable Version Here)

Aerko International

3410 NE 5th Avenue, Oakland Park Florida 33334

MATERIAL SAFETY DATA SHEET

DATE OF PREPARATION: April 24, 1986    EMERGENCY TELEPHONE #:(305) 565-8475

 UPDATE:  February 9, 2004      AFTER HOURS 800-424-9300

 SECTION I: PRODUCT IDENTIFICATION

Product Name:                    TOUCHE'        

Product Number:                AX-4-32

Product Class:                    RUBBER MOLD RELEASE

D.O.T. Shipping Class:       FLAMMABLE LIQUID, N.O.S. UN 1993

 SECTION II   HAZARDOUS INGREDIENTS 

                                                                                                                      OCCUPATIONAL

       INGREDIENT                                          PERCENT                      EXPOSURE LIMITS             VAPOR PRESSURE

                                                                                                                     TLV            PEL

TRADE SECRET:  As defined in                                                      1000 PPM     750 PPM                     184.0

Hazard Communication Act 29 CFR                                                25 PPM         25 PPM                         5.0

1910.1200 Para 1 (i) end                                                                  350 PPM        350 PPM                    100.0

Appendix D to CFR 1910.1200

SECTION III: PHYSICAL DATA

Boiling Range:                                                     >175OF

Vapor Density:                                                     Heavier Than Air

Percentage Volatile by weight:                       94%

Evaporation Rate:                                               Slower Than Ether

Weight per gallon:                                              8 lbs.

Specific Gravity:                                                  .922

Appearance:                                                        Clear to Light Amber Liquid

Odor:                                                                      Fruity Chemical Similar to Paint

SECTION IV: FIRE AND SAFETY EXPLOSION HAZARD DATA

Flammability Classification OSHA:                 Flammable Liquid

Shipping Classification D.O.T.:                        Flammable Liquid, N.O.S. UN1993

Flash Point:                                                          < 100oF

Flammable Levels in Air:                                  2.8% Lower Explosive Limit 13.2% Upper Explosive

Extinguishing Media:                                         Water Fog, CO2, Foam

 Unusual Fire and Explosion Hazards:  Do not expose to heat or flame or store above 120o F as high internal pressures cause leaking.

 Special Fire Fighting Procedures:  Full protective equipment including self contained breathing apparatus should be used, Fog nozzles should be used to cool closed containers to prevent pressure buildup.  Move undamaged containers from fire area if accomplished without risk.

SECTION V: HEALTH HAZARD DATA

 PRIMARY ROUTE (S) OF ENTRY:  Dermal, Inhalation, Ingestion

 EMERGENCY AND FIRST AID PROCEDURE

 EYES:  Protective splash goggles should be worn.  Flush eyes with large quantities of water to speed recovery. Face subject into wind or forced air source such as fans or air conditioning outlet.


 

SKIN CONTACT:  If this product comes in contact with the skin, wash with soap and large quantities of water and seek medical attention if irritation from contact persists.

 INHALATION:  If breathing difficulties, headaches, dizziness, or lightheadedness occur when working in areas with high vapor concentrations, person should seek air free of vapors.  If person experiences continued breathing difficulties, administer oxygen until medical assistance can be rendered.  If breathing stops, begin artificial respiration and seek medical attention.

 INGESTION:  If this product is swallowed, DO NOT INDUCE VOMITING. Seek medical attention if nausea persists.

PHYSIOLOGICAL EFFECTS AND HEALTH INFORMATION

 EYE EFFECTS:  This product is an eye irritant, Tearing and redness occur.

 This product has been thoroughly tested by FDA approved Labs and has been found to have minor non persistent eye irritation, to be non toxic, and not to cause dermatitis.

SECTION VI: REACTIVITY DATA

STABILITY:                                                                            Stable

HAZARDOUS POLYMERIZATION:                                    Will Not Occur

CONDITIONS TO AVOID:                                                    Heat, open flames, electrical and static discharges.

INCOMPATIBILITY (MATERIALS TO AVOID):                 Aluminum containers.

SECTION VII: SPILL OR LEAK PROCEDURES

 STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED:  Ventilate area.  Remove all possible sources of ignition.  Avoid prolonged breathing of vapors.  Confine spill with inert absorbent.  Wear protective equipment during clean up.

 WASTE DISPOSAL: Incinerate in an approved incinerator or dispose of in accordance with Local, State and Federal Regulations.

 SECTION VIII: SAFE HANDLING AND USE INFORMATION

 RESPIRATORY PROTECTION:  Use NIOSH/MSHA approved Chemical/Mechanical type filter system to remove a combination or particles, gas & vapor.  Use air line if necessary.

 VENTILATION:  Use adequate ventilation in volume and pattern to keep LEL and TLV's in Section II below recommended level to produce explosion or fire.  General mechanical ventilation should comply with OSHA 1910.94.

 PROTECTIVE GLOVES:  Use rubber gloves.

 EYE PROTECTION:  Safety glasses or goggles with splash guards or side shields.

 OTHER PROTECTIVE EQUIPMENT:   Prevent prolonged skin contact to contaminated clothing.

 SECTION IX: SPECIAL PRECAUTIONS 

PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING:  Store in a cool dry area away from sources of ignition.  When storing large quantities, store in building designed and protected against fire.

DO NOT STORE IN DIRECT SUNLIGHT OR ABOVE 120O F.

OTHER PRECAUTIONS:  "FOR INDUSTRIAL USE ONLY"  Do not take internally.  If ingested, DO NOT INDUCE VOMITING.  Consult a physician. 

SECTION X: Hazardous Material Identification System

HEALTH

            0-No Significant Health Risk

            1-Irritation or Minor Reversible Injury Possible

            2-Temporary or Minor Injury Occur

            3-Major Injury Likely Unless Prompt Action is Taken and Medical Treatment is Given

            4-Life Threatening; Major Permanent Damage Result from Single or Repeated Exposures

FLAMMABILITY

            0-Materials Will Not Burn

            1-Flash Point Above 200O F

            2-Flash Point Above 100O F below 200O F

            3-Flash Point Between 73O F and 100O F

            4-Flash Point Below 73O F

PHYSICAL HAZARD

            0-Material that are normally stable even under fire conditions and will not react with water.

            1-Material that are normally stable but can become unstable (self-react) at high       temperatures and pressures; react non violently with water to undergo hazardous polymerization in the absence of inhibitions.

            2-Materials that are unstable; react violently with water and undergo violent chemical changes with low risk for explosion.

            3-Materials that for explosive mixtures with water or undergo other chemical change at  normal temperatures.

            4-Materials capable of explosive water reaction, decomposition or polymerization.

Touche H.M.I.S.

Health: 1

Flammability: 3

Physical Hazard: 0

 

THE INFORMATION CONTAINED HEREIN IS BASED ON TECHNICAL DATA WHICH WE BELIEVE TO BE RELIABLE, HOWEVER, SINCE THE CONDITIONS UNDER WHICH THIS INFORMATION BE APPLIED ARE BEYOND OUR CONTROL WE CAN ASSUME NO LIABILITY FOR RESULTS OF ITS APPLICATION.  THIS INFORMATION SHOULD BE USED ONLY BY PERSONS HAVING SUFFICIENT TECHNICAL SKILL TO MAKE INFORMED JUDGEMENTS REGARDING ITS APPLICATION.